RUBBER MATS FOR ELECTRICAL PURPOSES
APPLICATION Rubber mats are used as floor covering around electrical panels as a safeguard to the life and limb of the workmen due to possible leakage of current and short-circuit. Rubber mats are used in power generation plants, sub-stations, workshops etc. |
CONSTRUCTION | |
| Composition : | Manufactured out of rubber compound of high quality Natural Rubber. | |
| Surface : | The rubber mats have chequered, anti-skid fluted design or plain on one side and plain at bottom as per the requirement of the purchaser. | |
| Thickness Range : | 8.5 mm to 25 mm for chequered or fluted 6.5 mm to 25mm for plain | |
| Length X Width : | 2.0 mtr X 1.0 mtr.
1.8 mtr X 0.9 mtr. |
|
| Colour : | Black unless otherwise specified by the purchaser. Any colour also available on request. | |
| Technical : | Tensile strength 50 kgf/cm2 | |
| Particulars : | Elongation at break 250% | |
| Voltage Test : | The rubber mats are tested to pass the voltage test at 15000 volts for one minute without any puncture or warming effect. | |
| Breakdown Strength : | Shall not fail at less than 40000 volts. | |